Waterbus Optima (barco a motor) - Venda

The boat is built on a Waterbus aluminum frame with floats. All walls and roofs are made of high quality composite material with exterior sheeting.

Walls of 8 cm thick - to minus 20 degrees C specs. Roof; 12 cm thickness. Resistant to a load of 280 kg pr 1m2, apart from areas without support (max 100 kg pr 1 m2)

The ship is built to the highest specifications with triple glazing, which includes 3 sliding doors. 1 in front. 1 in master bedroom and 1 in living room (starboard side)

There are heated floors (with individual temperature controls for all rooms on board) An ebersprecher cooler/ heater (spec 18 - 28 degrees C) with outlets in all rooms. (Runs on gasoline)

Electric heater is often used all over the boat with a total of 30 contacts for 230V. No gas is used

Contacts for solar panel use is mounted Contacts for possible battery "top-up" generator is mounted in the engineering room

4 jet-trusters are mounted. Powered by 8 high capacity batteries 2 power connections for land power Diesel and gasoline tanks; both 50 liters

A macenator is mounted in the toilet that consumes only 1.0 liters of water with each flush Hot water tank of 80 liters Washing machine with additional "quick drying" capacity

3 electric water pumps

Fresh water tank with a capacity of 130 liters Grey water tank with 100 liters Laundry tank with 50 liters

The "walkaround" is 60 cm wide The deck is all "eco-teak"

All others (railings etc) are of brushed high-quality aluminum

Living area 49.8 m2 Total with lower decks and deck "walkaround" 95. m2

Upper deck 70.5m2 (seating areas, barbecue etc) Sun terrace is 40m2... texto completo » menos texto