Bénéteau First 27 SE (парусная лодка) для продажи

Beneteau First 27 SE delivers fun and modern downwind planing sailing thanks to modern design and building technologies. Families will go cruising, you'll enjoy a fun and exciting day sailing, and she will win trophies on the club races. Interior of this pocket-cruiser can welcome up to 6 persons and offers separated bow-cabin, open space saloon, galley with freshwater, fridge and separated classic marine toilet.Board the ship and have fun!

Covers

- Bimini Top

- Lazy Bag

Electrical Equipment

- Shore Power Inlet

Electronics

- Depthsounder
- Log-Speedometer
- Wind Speed and Direction

- Plotter
- Autopilot
- Compass
- GPS

Inside Equipment

- Manual Bilge Pump

- Marine Head
- Battery Charger

Outside Equipment/Extras

- Solar Panel

Rigging

- Tiller
- Hydraulic Winch

Sails

- Battened Mainsail
- Gennaker/Cruising Spinnaker

- Furling Genoa

CONSTRUCTION:

Hull and deck constructed with Vacuum Infusion of Vinyl ester
resin, foam and Soric GRP sandwich with unidirectional and biaxial
laminates
Hull is reinforced with Infused GRP stringers in the keel and bow
sections
Hull and deck are moulded in single tone off-white,
Deck with high traction non-skid moulded
Carbon fibre beams laminated on keel box and glued to the deck to
support mast compression and keel hydraulic ram
Two transoms hung balanced rudders, built of GRP foam sandwich,
Red chainplates bolted to the main structural bulkhead
Bolts, screws and fittings are all made of stainless marine grade
stainless steel
Faired underwater areas, ready for sanding, epoxy primer and
antifouling application
SWINGING KEEL SYSTEM:

Swinging keel with “elephant leg” lead bulb, main steel structural
element and epoxy GRP enclosure
Laminated areas of the keel are pre-painted with epoxy primer for
easier antifouling treatment
Manually operated hydraulic pump with stainless steel hydraulic ram
built in the carbon fibre mast support
DECK EQUIPMENT:

60 cm high stainless steel pulpit, pushpit and six stanchions painted
in mat black, with double lifelines
Stainless steel bow and stern mooring cleats
Stainless steel chain plates for side shrouds and forestay painted in
mat red
Four Wichard folding pad eyes for lifting straps at mid-two stations,
2x Harken STA15 secondary halyard winches and 2x Harken STA20
jib and gennaker trim primary winches
2x Spinlock winchfeeder on the coachroof
Two rope bags and two winch handle bags, Outils Océans & First
branded
Wide mainsail traveller, installed over the tiller
Carbon tiller with Spinlock EA1200DS tiller extension
Laminated tempered glass windows on both sides of the hull
An opening hatch of 58 cm x 58 cm / 23 x 23 inch for light
ventilation and deck access to the mid-section compartment
An opening hatch of 25,5 cm x 25,5 cm / 10 x 10 inch for front
cabin ventilation
Bow anchor locker with Dyneema J3 staysail attachment point on
the deck
Stern storage compartment cover
Foldable outboard cockpit compartment with two top & one bottom
cover and engine bracket for internal combustion outboard (not
mounted)
Manual bilge pump operated from the cockpit
MAST & RIGGING:

CompoTech mast and boom with two sets of swept-back spreader build in high-quality carbon fibre
Ronstan Series 19 aluminium track for mainsail cars (cars not included; they are part of the mainsail option)
All carbon parts UV protected
Mast transport & storage bag
Continuous 1x19 standing rigging with
Bottle screw adjusters
Retractable carbon bowsprit controlled from the cockpit
Dyneema pole-out control line
Dyneema gennaker tackline
2:1 Dyneema mainsail halyard with Wichard MX8 halyard shackle
Dyneema jib halyard
2:1 Dyneema staysail halyard
Dyneema masthead gennaker halyard
Dyneema fractional gennaker halyard
9x Spinlock clutches for halyards, mainsail reefs and bowsprit
control lines
Ronstan blocks and cleats for the mainsail, jibs and gennakers
control lines
One tapered mainsheet with ball bearing low friction blocks
Three mainsail reef lines
Control line for the mainsail traveller
8:1 outhaul purchase led inside the boom
8:1 cunningham purchase
16:1 vang purchase
Three jib sheets
Spliced Dyneema jib inhaulers with a fixed length,
2:1 jib downhaulers with control lines, cleats and blocks
Two tapered gennaker sheets with blocks
Mast transport & storage bag
ELECTRICITY:

Custom electric control panel with five switches and smart Philippi
LCD battery control display
Remotely controlled master switch on the control panel
Standard 12V and USB plugs in the saloon
12V 70AH AGM battery
Ambiental indirect LED lights around the ceiling
One mid-section and two front cabin battery LED lights
Masthead LED navigation and anchor light
Sentinel tracker to connect, monitor and control boat systems
remotely on your mobile phone with a 1-year subscription
Pre-wiring for most of the available electrical options
INTERIOR:

Bulkheads and furniture lightly covered with mat paint with white
gel coat on the moulded parts for light, clean and low maintenance
finish
Front Cabin:

Double V-berth with insubmersibility volume underneath
Opening hatch of 25,5 cm x 25,5 cm / 10 x 10 inch for front cabin
ventilation
Mid-section compartment / Wet room:

An opening hatch of 58 cm x 58 cm / 23 x 23 inch for light
ventilation and deck access to the mid-section compartment
The base for chemical or flush toilette with monolithic
reinforcements for valves on the starboard side
Saloon:

Bright and spacious saloon area with large Plexiglass companionway
washboard and sliding hatch
Dedicated storage place for washboard back of the companionway
steps
Benches on both sides of the saloon, divided into four wooden
covers of the storage space underneath
Main electric box and battery in aft port compartment and keel
hydraulic pump under aft starboard compartment
Padded back-supports with gimbal cooker holder attachment points
on both sides and storage behind the nets
Wide berths in the stern on both sides, with insubmersiblity
chambers underneath
Front and aft keel box covers with table attachment point with a
screw on the aft
Electric boxes under the ceiling and under the companionway
Extra storage room under the companionway and engine box for
fresh-water tank or other systems, with cover
Two ergonomically shaped wooden companionway steps
Well insulated 40L icebox below bottom companionway step, with
fridge compressor upgrade possibility
Light grey EVA foam floorboards
Shrouds attachments counter plates painted in mat red
PROPULSION

MERCURY 9,9 HP OUTBOARD ENGINE WITH ELECTRIC
STARTER:

Mercury 9.9 HP outboard engine (short shaft, remote controls, electric starter), integrated into the cockpit engine compartment
Throttle and gear remote control system with Teleflex commands, removable Spinlock handle and push-pull cables
Electric starter with key
6 A alternator for charging of the battery
Custom installation parts (engine foot rubber support, storage position padding)
Standard Mercury 12 L fuel tank with connection hose
Strap with attachment points for fixation of the petrol tank
Complete installation and electric wiring
SAILS & RIGGING

FIRST 27 SE FACNOR FLATDECK FURLER FOR THE JIB
(FD110):

Facnor FD110 flatdeck furler with flat aluminium profile
Spinlock clutch for furling line on the side of the cockpit
Customised forestay toggle
BARTON RODKICKER/BOOMKICKER:

Barton composite Boomstrut
Prevents the boom from dropping into the cockpit or onto the coach roof
Boom and mast foot reinforcement
ADJUSTABLE JIB INHAULERS:

Adjustable jib inhauler for precise 3D trim of the jib
6:1 purchase on the coachroof
Replacing standard fix-length jib inhauler and allowing active trim of the jib sheeting angle
FIRST 27 SE NORTH SAILS SQUARE TOP MAINSAIL:

Square top mainsail with full battens and three reefs
Durable and robust NPL Tour laminate material in light grey, triradial cut, 26,2 m2 / 282 sq ft
Ronstan Series 19 Ball-Bearing Batten Car System for aluminium
mast track
FIRST 27 SE NORTH SAILS J1 JIB FOR FURLER:

J1 furling jib with vertical battens for Facnor FD110
Durable and robust NPL Tour laminate material in light grey, triradial
cut 19,5 m2 / 210 sq ft
FIRST 27 SE NORTH SAILS J3 FURLING STAYSAIL WITH FURLER:

Furling J3 jib with structural luff to be hoisted on the dedicated 2:1 halyard
Triradial cut, hydranet material
Facnor FX 1500+ furler set with spliced continuous furling line
Wichard MX6 halyard shackle
FIRST 27 SE NORTH SAILS A5 FRACTIONAL GENNAKER IN A
CHOSEN COLOUR:

Fractional gennaker, reacher, 64 m2 / 689 ft2
Nylite 90 - Performance Ripstop nylon, 1,12 oz.
Colour options – RED, WHITE or BLACK
NAVIGATION & ELECTRONICS

ELECTRIC PUMP UPGRADE FOR HYDRAULIC KEEL SYSTEM:

Upgrade of standard manual hydraulic system with 12V electric pump
Double safety control switches on the electric panel
Manual operation of the keel remains possible
COMPASS PLASTIMO CONTEST 101:

Plastimo Contest 101 compass mounted on bulkhead next to companionway
Compass light connected to navigation lights switch
SOLAR PACK:

Sunbeam Tough series walkable 55W solar panel
Placed on the cabin in front of the mast with connection cable hidden under the panel
Smart MPPT solar panel regulator for up to 30% better panel efficiency
and Bluetooth connectivity
WINDEX

GARMIN COASTAL PACK:

GMI 20 large and bright 4’’ QVGA colour displays with LED backlighting, installed on the coachroof
Airmar DST810 depth, speed and temperature transducer
gWind race wired wind transducer
External GPS 24xd antenna
NMEA2000 backbone kit and wiring
Dedicated switch on the control panel
GARMIN AUTOPILOT PACK:

Underdeck autopilot installation, instantly available for use
Reactor™ 40 Course Computer Unit with ECU 10 pack
GHC 50 Autopilot Instrument for operation and control
Reactor™ Autopilot Remote Control
GRF 10 Rudder Feedback Sensor
Raymarine mechanical linear drive, Type 1
Wiring, installation cables, quadrant arm and other assembly parts
Dedicated switch for an autopilot on the control panel
GARMIN CHARTPLOTTER PACK:

GPSMAP 723 touchscreen Chartplotter with high-resolution IPS display
Supplied with Worldwide Base map, WITHOUT detailed regional charts
Garmin Sailassist™ sailing features
Installed on unique swinging bracket at the companionway, with
adjustable angles for perfect visibility and inside use as well
Wiring and dedicated control panel switch
GARMIN VHF 215I MARINE RADIO WITH AIS:

Garmin VHF 215i AIS Marine Radio with standard Class D Digital Selective Calling (DSC) functionality
Garmin AIS 800 Blackbox Transceiver, including VHF antenna splitter for Class-B AIS system
External GA 38 GPS/GLONASS antenna
SCOUT KM-10S VHF Fiberglas Antenna
Wiring and dedicated control panel switch
230V CHARGING PACK:

230V charger with fuse
External shore cable plug
Shore cable + adapter to standard 230V plug
Internal 230V plug
COOKER GIMBAL:

Aluminium gas cooker gimbal optimised for Jetboil Flash cooker (not
included)
Can be fixed on the saloon back-supports on both sides
CLASSIC TOILET:... весь текст » меньше текста